Digidim Blinds Controller 490
Rated 3.5/5 based on 11 customer reviews

Digidim Blinds Controller 490

Availability: on request
R 5,546.96
EXCLUDING VAT
R 6,379.00
INCLUDING VAT


NB: Mobicred will only consider items priced under R35000

Quotes requested

Blinds_Controller

The 2-Channel Blinds Controller is a DALI-compatible interface unit that allows control of blinds and curtains in a DIGIDIM lighting control system. The blinds controller is a DIN-rail mounted unit that provides two independent control channels, each with two single-pole, volt-free contacts for switching up to 550 W up/down or power direction motors from a DIGIDIM system.

The unit has a status LED, a physical selection switch and relay-state indicators. The status LED provides status and a fault indication. The physical selection switch is used to identify the device during system configuration. The relaystate indicator LEDs are illuminated when the respective relay is closed.

Note: This unit does not contain a DALI power supply. Therefore, one must be present elsewhere in the system.

 

Key Features 

  • Up/Down mode operates in a ‘Break before Make’ manner to prevent motor damage. 
  • Relays are internally isolated permitting separate mains phases to be used for each control channel. 
  • All DALI functions are programmed with either DIGIDIM Toolbox or Designer software. 
  • DIN-rail mounted and only 88 mm wide.

Blinds_Controller

The 2-Channel Blinds Controller is a DALI-compatible interface unit that allows control of blinds and curtains in a DIGIDIM lighting control system. The blinds controller is a DIN-rail mounted unit that provides two independent control channels, each with two single-pole, volt-free contacts for switching up to 550 W up/down or power direction motors from a DIGIDIM system.

The unit has a status LED, a physical selection switch and relay-state indicators. The status LED provides status and a fault indication. The physical selection switch is used to identify the device during system configuration. The relaystate indicator LEDs are illuminated when the respective relay is closed.

Note: This unit does not contain a DALI power supply. Therefore, one must be present elsewhere in the system.

 

Key Features 

  • Up/Down mode operates in a ‘Break before Make’ manner to prevent motor damage. 
  • Relays are internally isolated permitting separate mains phases to be used for each control channel. 
  • All DALI functions are programmed with either DIGIDIM Toolbox or Designer software. 
  • DIN-rail mounted and only 88 mm wide.